DIGIBOX, Setting Up The Remote
If you can't find your manual - here's the answer
| 1. Make sure the TV is switched on and that means out of stand-by mode |
| 2. Press the tv button on the Sky remote. |
| 3. Hold the select button and the red button for around 2-5 seconds, the red light on the remote will blink twice. |
| 4. Press the TV button on the Sky remote again |
| 5. Key in the four digit code for your TV, see table below. The red light on the Sky remote should again blink twice. If the light only blinks once, our advice is start again. |
| 6. Press the standby key on the remote. |
* If the TV switches off, press the select button again and the red light should blink twice. Mission completed. |
*If the TV doesn't switch off then press the TV button, followed by the standby button. Keep repeating this process until the TV switches off - then press select and that code is now stored. |
The four-digit codes are:
|